Publicité
2. General
2.3 Description of the machine
The drawer assembly jig has been designed for ArciTech /
InnoTech drawer systems.
All system related sizes, between maximum and minimum
dimensions, can be set. The dimensions specified are key
dimensions which can be set using fixed stops.
Assembly jig dimensions:
Length: 1,086 mm
Width: 1,525 mm
Height:
656 mm
Space required by the machine
The space required by the drawer assembly jig is largely
governed by drawer dimensions.
Machine life
The machine's life will depend on whether or not it is used
for its intended purpose, on adherence to regular servicing
intervals and on the regular replacement of expendable parts.
2.4 Liability
Defects must only be rectified by competent personnel.
Our liability is restricted to damage caused while using
the system in the intended manner. We shall not be liable
for safety defects not yet identifiable on the basis of the
current state of the art.
Failure to:
· observe safety advice for operating personnel
· observe advice on particular hazards
· observe the ban on unauthorised modifications and
changes
· use replacement and expendable parts
or auxiliary materials other than those approved by te
manufacturer will rule out any liability on our part for the
consequences.
76
3. Safety
3.1 Information on signs, symbols and labelling
The safety precautions in the operating instructions are struc-
tured as follows:
Danger
Danger
This danger note draws attention to an immedi-
ately dangerous situation that will lead to death
or serious injuries if the safety measures are not
followed.
Warning
Warning!
This danger note draws attention to a potentially
dangerous situation that may lead to death or
serious injuries if the safety measures are not
followed.
Caution
Warning of tripping hazard!
This danger note draws attention to a potenti-
ally dangerous situation that may lead to minor
or slight injuries if the safety measures are not
followed.
Note
This advice draws attention to potential damage
to property or to a process of particular interest /
i
importance that may occur if the safety measu-
res are not followed.
3.2 General
The machine described in the operating instructions is built to
the state of the art and safe to operate.
It complies with DIN EN 12100.
Hazard zones are made safe in compliance with the regulati-
ons. However, the machine may present hazards if it is used
by untrained personnel improperly or not for the intended
purpose.
This may then result in risks to life and limb, jeopardise the
machine and prevent it from working efficiently.
Any person given the task of installing, starting, operating,
servicing or repairing the machine at the user's premises must
have read and understood these instructions, in particular the
section on "Safety precautions".
In his or her own interest, the safety officer at the user
company should obtain written conformation from operating
personnel that they have received instruction and training
and are familiar with all safety precautions before they use
the machine for the first time.
The safety guards must never be removed
or taken out of operation.
If safety guards need removing for maintenance and repair
work, they must be refitted as soon as such work has been
completed.
The machine must only be used if it is in proper working order
and operated by trained, authorised personnel.
Work requiring specialised knowledge (e.g. pneumatic system)
must only be carried out by persons specifically trained and
suitable to do so.
Switch off energy sources before carrying out repair, servicing,
installation or cleaning work.
77
Publicité
Chapitres
Dépannage
