Publicité
10. Taking out of service / 11. Disposal
10. Taking out of service
When taking the machine out of service, it must be dis-
connected from the compressed air supply to dissipate the
residual or stored energy.
Warning
Risk of injury!
The compressed air supply must be disconnected
by industrial mechanics or by persons of similar
qualification.
11. Disposal
Sort machine parts before disposal and dispose of them in
an environmentally friendly manner.
11.1 Protecting the environment
Caution
Caution!
The obligations prescribed in law with regard to
avoiding waste and proper recycling / disposal
must be followed during all work on and with
the machines!
Particularly when carrying out installation, repair
and servicing work, substances hazardous to
water, such as
· lubricating greases and oils
· solvent based cleaning fluids,
must not be allowed to pollute the ground or get
into the sewer system!
These substances must be kept, transported,
loaded and disposed of in suitable containers.
92
11.2 Scrapping
If the machine is ever taken out of service for good, the laws
and regulations on disposal in force at that time must be
observed and met.
At the time of final shutdown and disposal, it is necessary to
dismantle and remove the entire energy supply system and
dispose of the lubricating oils.
At the end of its useful life, machines must be disposed of by
a specialist company qualified to do so.
It makes sense to check which materials can be recycled and
then also do so.
11.3 Oil and oily wastes
Caution
Caution!
Oil and oily wastes are a huge potential threat to
the environment. This is why they are disposed of
by specialist companies.
Channel these wastes into the company's inter-
nal disposal department which will then pass
them on to specialist companies.
12. Replacement and expendable parts
12. Replacement and expendable parts
Note
The replacement and expendable parts are
i
shown in the appendix.
Always state the following details when orde-
ring:
System:
Position in list of parts:
Designation:
ArciFit 300 / InnoFit 300 drawer assembly jig for manually
assembling drawer systems (ArciTech / InnoTech)
Please note that the manufacturer's declaration or declaration
of conformity given by Hettich Maschinentechnik GmbH &
Co. KG as manufacturer will lose its validity if non approved
replacement parts are installed.
93
Publicité
Chapitres
Dépannage
