8. Troubleshooting
Machine malfunctions must only be rectified by qualified
staff instructed to do so by the person responsible.
In identifying the source of malfunction attention must be
paid to the entire area surrounding the machine. The ma-
nufacturer must be immediately notified of any damage
occurring during the warranty period.
8.1 Safety precautions
Warning
Safety regulations while identifying the sour-
ce of malfunction and rectifying malfunction.
Observe the accident prevention regulations!
· In the event of a mechanical malfunction,
make sure that the assembly jig is depressu-
rised!
· Prevent the machine from switching back
on again and attach a warning sign!
90
9. Servicing and maintenance
Maintenance intervals:
Work to be performed
Interval
Retighten screw connections
half yearly
Clean oil, grease and dirt off the assembly jig
half yearly
Visually check the tolerance plates for dama-
half yearly
ge every six months
Visually check the pins in the stops for dama-
half yearly
ge
Warning
Risk of injury!
Servicing and maintenance work must only be
carried out by instructed, qualified personnel.
9.1 Checking the safety guards
Regularly check safety guards to make sure they are com-
plete and in proper working order.
· Check the safety guards every day for proper working order.
9.2
Labelling, information signs
Labelling/information signs must be
· cleaned with a cloth,
· checked for secure attachment and legibility,
· replaced if they are damaged.
91