Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Only use the same type of
batteries / rechargeable bat-
teries. Do not mix used and
new batteries / rechargeable
batteries.
Remove batteries / recharge-
able batteries if the product
will not be used for a longer
period.
Risk of damage of the
product
Only use the specified type
of battery / rechargeable
battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the bat-
tery / rechargeable battery
and the product.
Clean the contacts on the
battery / rechargeable battery
and in the battery compart-
ment before inserting!
Remove exhausted batteries /
rechargeable batteries from
the product immediately.
Mounting
(see Fig. A)
Note: Clean the surface well
onto which you wish to mount the
product. The surface must be
clean, free from grease and dry.
The adhesion of the double-sided
adhesive strip
5
wise be limited.
Note: Before use, check on a hid-
den area of the surface, whether
the adhesive can cause damage.
Peel the protective film off the
adhesive strip on the back of
the LED strip
the LED strip in the desired
location.
Secure the LED controller
with the included double-sided
adhesive strip
cluded screws
Connect the power supply
with the LED controller
Then connect the LED control-
ler
to the LED strip.
4
Note: When connecting the
LED controller
LED strip, be sure to match
up the VGGD mark on the
,
may other-
10
and secure
2
4
or the in-
5
.
8
3
.
4
with the
4
GB/IE/NI
11
Publicité
Chapitres
Table des Matières
