Mounting The Led Light Panel; Operating The Led Panel Light With White Light; Operating The Led Panel Light With Rgb Colour Change - LIVARNO LUX 14102804L Instructions D'utilisation Et Consignes De Sécurité

Safety
Remove the battery from the device if it is not
going to be used for a prolonged period.
Only use the specified battery type!
When inserting the battery ensure the correct
polarity! This is shown in the battery compartment.
If necessary, clean the battery and device
contacts before inserting the battery.
Promptly remove drained batteries from the
product.
M ounting the LED light panel
CAUTIon! RISK oF ELECTRIC SHoCK!
Disconnect the light from the mains circuit before
installing. To do so, remove the fuse or switch off the
circuit breaker in the fuse box 0 position.
U se the slotted holes intended for the mounting
bracket to mark the holes for the screws
2
N ow drill the mounting holes. Be careful not to
damage the supply line.
I nsert the dowels
1
Fig. A).
S lightly screw the screws
brackets (see Fig. B).
2
F asten the mounting bracket
screws (see Fig. C).
4
O pen the junction box
R emove the anti-kink sleeve
box .
5
F eed the mains cable (external) through the
anti-kink sleeve .
8
C onnect the connection cable of the light to the
mains cable using the terminal block (see Fig. D).
B e sure to correctly connect the individual
conductors of the mains cable (external): live
conductor, black or brown = symbol L, neutral
conductor, blue = symbol N. (see Fig. D). Any
possibly present green / yellow wire present is
not connected. The earth wire is not required,
as the light is Protection Class II /
P lace the anti-kink sleeve
recess inside the junction box
cap is seated correctly.
C lose the junction box
8 GB/IE
4
into the drilled holes (see
into the mounting
3
with the included
2
.
5
from the junction
8
.
in the designated
8
. Ensure the end
5
.
5
N ow attach the LED panel light
ing brackets
2
R eplace the fuse or switch on the circuit breaker
(Position I) inside the fuse box.
Your LED panel light is now ready to use.
o perating the LED panel light
with white light (14102804L)
Switch the light on and off and adjust the brightness
using the upstream wall switch.
P ress the wall switch to switch the light on. After
switching it on, the light is on the brightest setting.
R educe the brightness by briefly and successively
pressing the wall switch (switching off and on
within one second).
note: With the light dimmed, you can set it to
. the brightest setting by switching it off for more
than one second or by briefly switching the wall
switch off and on (within one second) whilst on
the dimmest setting.
o perating the LED panel
light with RGB colour change
(14102904L)
– 8 individual colour selections
Button : on / off
Button : Play / Pause – controls the colour
programs
button : brighter
button : dim
AUTO button: automatically cycles through the
colour programs
JUMP 3 button: 3 colour static colour change
JUMP 7 button: 7 colour static colour change
FADE 3 button: 3 colour flowing colour change
FADE 7 button: 7 colour flowing colour change
FLASH button: white light strobe function
SPEED – button: reduce speed
SPEED + button: increase speed
to the mount-
6
using the screws (see Fig. E).
3