Mounting The Product; Start Of Operation; Using The Product - LIVARNO LUX Z31685B Instructions D'utilisation Et Consignes De Sécurité

Clean the contacts on the battery / rechargeable battery and
in the battery compartment before inserting!
Remove exhausted batteries / rechargeable batteries from the
product immediately.

Mounting the product

Note: Remove all packaging materials from the product.
Note: You will need an electric drill to install the product.
Make sure you will not be drilling into electrical, gas or water lines
inside the wall. Use a power drill to drill the holes into the brick
wall. Always observe all safety instructions for the power drill in
the manual for the power drill. Death or injury due to electric
shock may otherwise result.
CAUTION! RISK OF INJURY! Refer to the operating instructions
for your electric drill.
CAUTION! Ensure that you do not damage any cables in the wall.
Please see figure A (with screws
(with double adhesive tape
Note: The substrate should be dry, smooth and free of dust
and grease.
Note: Allow the wall bracket
bond for at least 24 hours. Otherwise the adhesive action
could be detrimentally affected.
Note: If the double adhesive tape
a long time, sticky residue may remain on the surface when
removed. If necessary, use an adhesive remover. Test a small
area prior to cleaning the respective area. Follow the manu-
facturer instructions.

Start of operation

Using the product

Note: Before first use remove the insulation strip.
and dowels
5
) for mounting the product.
6
to build up its adhesive
4
has been in place for
6
) or B
3
GB/IE 19