Preparation; Required Tools And Material; Prior To Installation; Initial Use - LIVARNO LUX 54739 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Safety / Preparation / Prior to installation / Initial use / Maintenance and Cleaning
Do not look directly into the light source (lamp,
LED, etc.). Do not look into the light source
(lamp, LED, etc.) with an optical instrument
(e.g. magnifier).
The light bulb is not replaceable.
If the light bulb has reached the end of its life,
the entire light needs to be replaced.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil/marking tool
- Voltage tester
- Screwdriver
- Electric drill
- Bit (ø approx. 0.6 cm)
- Side cutting pliers
- Ladder

Prior to installation

Important: The electrical connection must be
established by a qualified electrician. This person
must be familiar with the properties of the light and
the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the
light itself, before you install it.
Make careful preparations for mounting and
allow yourself adequate time. Organise all
parts and any necessary additional tools or
materials before starting so they are easy to
reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
8 GB/IE/NI
at all times. Never install the light if you are
having difficulty concentrating or do not feel
well.
Before installation ensure that the circuit to
which the light will be connected is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (position 0)
(see Fig. A).
Verify that the components are not energised
using a voltage tester.
Ensure that you do not damage any electrical
cables, gas or water pipes when you drill into
the wall.
Please refer to the instructions for use for your
power drill.

Initial use

Mounting the light

Prior to installation, remove the fuse or switch off
the circuit breaker (0 setting) in the fuse box (see
Fig. A).
Mount the lights as depicted in Fig. B-D.
Replace the fuse or switch on the circuit
breaker in the fuse box (I position) (see Fig. E).
Your light is now ready to use.

Switching the light on/off

Use the wall switch to switch the light on or off.

Maintenance and Cleaning

WARNING! RISK OF ELECTRIC
SHOCK!
Disconnect the light from the mains circuit before
cleaning. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (position 0).