Preparation; Required Tools And Material; Start-Up; Mounting The Light - LIVARNO LUX 14118405L Instructions De Montage, D'utilisation Et Consignes De Sécurité

Safety / Preparation / Start-up
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts
etc. can turn into dangerous toys for children.
Do not cover the lamp or the mains plug with
objects. Excessive heat can result in a fire.
Never leave the lamp unattended whilst in use.
Safe working
Mount the light so that it is protected from mois-
ture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never assemble the lamp if you are unfocused
or feel unwell.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
– Screwdriver

Start-up

Mounting the light

Note: When assembling the stand tube
not to damage the mains lead inside the lamp.
14118405L / 14118406L
Unfold the floor lamp.
Insert the connector (metal)
part of the tube
4 b
8 GB/IE/NI
be sure
4
into the bottom
8
and screw in place.
Carefully pull the mains cable
tube .
4
Screw the tube
4
Note: Be sure to tightly secure the tube
ensure it is stable.
Position the floor lamp upright.
Adjust the lamp arm
Adjust the lamp head
Push any cable protruding from the joints as far
into the tube or lamp arm
4
Connect the supply cable
cable .
11
Connect the mains cable
.
6
Plug the mains plug
socket.
14118502L
Unfold the floor lamp.
Install the base
5
(base) onto the base plate (base).
Insert the screws
9
base from below.
5
Use the two screws
base .
5
Position the light upright.
Adjust the lamp arms
sired position.
Adjust the lamp head
Connect the supply cable
.
6
Plug the mains plug
socket.
Your light is now ready to use.

Switching the light on / off

Use the dimmer switch
to switch the light on / off.
1
To dim the light, touch / press the dimmer switch
several times. This light has 4 dimmer set-
2
tings.
out of the
11
onto the base .
5
4
to the desired position.
3
to the desired position.
1
as possible.
3
to the mains
10
to the mains plug
11
into a properly installed
6
by placing the metal plate
all the way through the
to secure the tube to the
9
on the light to the de-
3
to the desired position.
1
to the mains plug
10
into a properly installed
6
on the lamp head
2
to