Before Initial Use; Mounting - LIVARNO LUX 102618-14-01 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Before initial use

Mounting

First install all the separate components of the light as
shown in Figure A.
Note: You can fit the LED driver
of the light for glass
1
edge lighting using either the screws or using the
7
double-sided adhesive tape .
3
If you choose installation using double-sided adhesive
tape, please remove the protective foil from the back first
and stick it to the intended area, pressing firmly.
Make sure that the surface is clean, dry, smooth and free
of grease.
Insert the short edge of the metal clip with LED under
5
the glass and twist it to slip it onto the glass (see Fig. B).
Carefully move the metal clip with LED all the way onto
the glass.
Note: Always make sure that the LED touches the edge
of the glass, this might otherwise affect the lighting
effects.
The battery of the remote control is already inserted.
6
Remove the insulating stripes from the battery compart-
ment before first use.
10 GB/IE