Elvox ZKN1 Mode D'emploi page 32

GB
Programming the remote controls
1) Under no circumstances modify the length of the aerial cable!
Remove the band from around the red aerial cable, pushing it upward (7) through the rear wall of the box, extracting it and fixing it (Fig. 28).
Storing the radio control code
Press and keep pressed the push-button on the circuit board for at least three seconds until the led switches on. Now release the button and send a
code from the radio control. If the operation was carried out correctly the led switches off.
Cancelling all the codes from the storage
Press and keep pressed the push-button on the circuit board for at least three seconds until the led switches on. Release the push-button and press
it again. The LED will start flashing. Press the puss-button again and keep it pressed for at least three seconds until there is a flashing with a higher
frequency and finally the led switches off.
N.B. The circuit board, with the 433 MHz receiver, can store up to 30 different radio control codes.
2 channel (ET03) and 4 channel (ET04) radio control "SAW RESONATOR" frequence stabilizer, with 433.92 MHz operating frequency. Powered by
a 12V D.C.battery.
Dimensions: 40x11x75
Replacing the battery of the radio control
Open the cover using a screwdriver. Replace the battery making sure that the contacts are clean. The battery to be used on Radiocontrols is the 23A
- 12V c.c. type.
Programming of remote control
Prior to the initial programming of the hand-held transmitters, clear the memory of the radio receiver.
ZKN1 - ZKN2
SPECIFICATIONS
32/56