Electrical Control Unit - Elvox ZKN1 Mode D'emploi

Electrical connections:
Follow the enclosed instructions to connect the cables for the safety devices.Remember that:
1) The mains power supply cable (230 Volts) provided must not be either cut or extended.
2) In accordance with European safety regulations it is recommended that an external two-pole switch be fitted, to enable the power supply to be swit-
ched off during maintenance of the swing mechanism.
3) All the appliances to be connected externally must be equipped with suitably insulated power contacts, in compliance with IEC 364-4041 paragraph
411.1.3.1.
4) Live components must not be earthed or connected to live components or protective wires from other live circuits.
5) When laying the cables for external appliances, comply with IEC regulation 364-4-41 paragraph 411.1.3.2.
6) Affix clear and easily legible warning signs informing of the presence of an automatically opening door.
7) Installation of security device for pedestrian door:
If the garage door is provided with pedestrian door, but without security device for the same, install the ELVOX security device Art. ZN26.
]
VAC
Transformer power input
VAC
] Open contact for optional external
COM
command.
AP/CH
]
C-track power supply
Terminal for safety devices:
1-2) Safety connection (N.C.)
1: signal 2: earth
3-4) Output +24V DC, max. 0,1A, for example powering a photocell
3: +24V DC 4: earth
5-6) Connecting to flashing light 24V DC (max. 34V), max 1A
Fuse:
1 fuse 1AT/250V; 5x20 mm
output 24V
Description of control unit terminals
ZKN1 - ZKN2

ELECTRICAL CONTROL UNIT

29/56
7 8 9 10 11 12
GB