Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
ELECTRICAL INSTALLATION
A
B
23
A 24
3
1
2
2
1,6m
4
4
9 5
25
6
S 6
2
5
1 5 0
c a
27
2
3
C
1
2
3
3
1
2
2
2
4
4
4
1,6m
26
5
1
4
2
1
ZKN1 - ZKN2
Fig. 22) Install the box containing the control unit, preferably close to
the garage exit door, so as to use the existing power socket.
The control box is powered with 230V A.C., all loads and
commands are powered with 24V A.C. low tension through a
200VA (EN60742) safety transformer.
N.B. The cable connecting the control unit and the C-track
has a maximum length of 6900 mm, and it must not be ex-
tended!
Fig. 22
Fig. 23) To connect the cable in the control unit, unfasten screw (1)
and remove the cover over the box courtesy light (2).
4
N.B. The power supply to the control unit must not be turned
on yet.
Fig. 24) Choose a suitable location for the installation of the control
B 24
housing (1), preferably near a power socket (2).
Minimum height from the floor - 1.6 m.
Please note when selecting location of control unit housing
(1) that the maximum length of the control cable (3) is 6900
mm and no longer!
• Install the control line (24 V) (3) to the control housing (1)
in the garage.
Do not yet plug in the power plug (4)!
Be careful not to drill into the socket outlet feeder and
do not plug the mains plug in yet!
Fig. 25) • Drill 2 holes (Ø 6 x 40 mm deep). Place plugs (2) in the
holes.
3 4
• Position, align and then secure the control housing using 2
screws (1) and 2 washer (6).
Fig. 26) • Insert the end of the control cable (5) into the rear of the
control unit (4).
• Connect the control cable (5): connect the core marked 3
(green) to terminal 3 and the core marked 4 (red) to terminal
4 of direct socket unit (1). Shorten the control cable (5) if
necessary.
Fig. 27) • Plug the control board (1) into the basic rack (2) and into
the terminal bar (3). Replace the cover (4) and tighten the
screws (5). Mount the lamp hood (6).
6
5
4
28/56
Publicité
Table des Matières
