Main Features - Elvox ZKN1 Mode D'emploi

The ZN10 electromechanical operator is designed for sectional and spring or counterbalance up and over doors.
Thanks to its push-pull and closing force, 650N, it will open and close doors up to 10 m
This generation of operators is designed with the accent on ease of installation but also on the strength of the materials employed.
The ZN10 operator integrates perfectly with the design of any up and over door without essentially altering its appearance. It also features quiet and
linear operation which renders it safe and agreeable to use, thanks not least to a courtesy light timed to switch off after 3 minutes.
Total safety
guaranteed by the use of low voltage (12V) motors, thus eliminating the risk of electric shocks or accidental electrification of the structure.
Electronic clutch
if the door is obstructed by an obstacle, an electronic device will immediately stop the automatic system as soon as the slightest hint of abnormal fric-
tion is detected, and reverse the movement by about 10 cm.
Easy to install
Simpler electrical installation thanks to the separate control unit, optimizing maintenance and assembly (can be connected to the power supply using
an existing socket). The control unit lights up automatically (when the motor is activated) and has a button for opening and closing the door.
The absence of any "control head" at the end of the mechanism, and consequently the reduction in length of 310 mm, is especially advantageous in
situations where space may be limited.
Reliable
With the new operating principle of a motor travelling along a fixed chain in a track, the automatic system is quiet and long-lasting.
Maximum door dimensions *
Max. width:
- Up-and-over door: 5000 mm
- 5000 mm
Sectional door:
-
Side-opening sectional door or lateral shutter door:
Rail 2600 2350 mm
3000 2750 mm
Rail
3400 3150 mm
Rail
- Canopy and non-protruding door:
Height (approx.):
- Up-and-over door:
2600 2600 mm
Rail
Rail 3000 3000 mm
Rail 3400 3400 mm
-
Sectional door:
Rail 2600 2350 mm
3000 2750 mm
Rail
3400 3150 mm
Rail
- Side-opening sectional door or lateral shutter door:
2600 3000 mm
Rail
-
Canopy and non-protruding door:
Rail 2600 1900 mm
3000 2300 mm
Rail
3400 2700 mm
Rail
Duty cycle: 15 15 15 %
* door according to EN 12604, EN 12605
Packaging (L x W x H):
- Drive 790 x 160 x 160 mm
- Rail 2600: 1665 x 160 x 50 mm
ZKN1 - ZKN2

MAIN FEATURES

max.22,5 245
35
30
375
2600
176
4000 mm
max without difficulty.
2
3240 /3640 /4040
115
3000 / 3400
1
Door type Accessories
1 Up-and-over door
Canopy and non-protruding door
2 Sectional door with Sectional door
3 Side-opening sectional door
*
As standard in ZKN2 kits
21/56
max.
214
252
120
0
1 5
3
2
No special accessories required
Tilting arm*
double runner rail fitting
Please consult specialist retailer
GB