Elvox ZKN1 Mode D'emploi page 22

GB
The ZN10 operator does not cause particular handling problems during
transport.
The standard version must be combined with the 2600 mm guide (wor-
king stroke of motor), art. ZN20. The two components are packed in
small cardboard boxes. They must be stored in a dry area that is pro-
tected from the weather.
Contents of article ZN10 (Fig. A).
- No. 1 control unit with electronic card and 433 MHz receiver
- No. 1 electromechanical operator
- No. 1 longitudinal rod and door corner fitting
- No. 1 front bracket supporting the track
- No. 1 ceiling suspension bracket for the track
- No. 1 instruction manual
- No. 2 remote controls Art. ET03
Contents of article ZN20 (Fig. A).
- No. 2 C-tracks length 1600 mm.
- No. 2 sliding limit switches
- No. 1 chain with chain raceway
- No. 1 snap-on component with cable for connections to the control
unit (6900 mm)
- No. 1 connector for the two C-tracks
- No. 1 ceiling suspension bracket
- No. 1 bag containing material required for assembly.
Assembly material in the bag (Fig. B)
- No. 4 wood screws 8x60
- No. 4 plugs S10
- No. 5 washers 8.4
- No. 2 wood screws 4x50
- No. 2 plugs S6
- No. 5 hexagonal head screws for metal plate, 6.5x19
- No. 1 long bolt 10x35
- No. 1 short bolt 10x35
- No. 2 safety clips
- No. 1 self-locking nut M8
- No. 1 suspension spring
- No. 1 fixing pin M8x110
- No. 1 two-component chain-link
In addition to Art. ZN10-ZN20, the Kit ZKN2 also contains Art. ZN21 (curved arm).
After unpacking the operator and guide, make sure they are undamaged and check that all the accessories listed are present. In case of doubt, con-
tact your dealer immediately.
Central unit supply voltage
Nominal frequency
Motor supply voltage
Nominal absorbed current
Nominal absorbed power
Maximum pair
Nominal hauling power
Maximum speed
Absorbed power in stand by
Relative noise (only automation) < 75dBA
Operating temperature
Working cycle
Protection degree
Maximum door surface
Radio receiver
Courtesy light
Weight
Useful run stroke
N.B. doors with a height exceeding 2600 mm require the addition of an extension Art. ZN22 of 1600mm (working stroke 4,200 mm.).
- When making your purchase, ensure that the product is provided with a rating plate indicating the technical characteristics, and if this is not the case,
advise the manufacturer and/or dealer immediately.
- Appliances that are not fitted with a rating plate must under no circumstances be used, penalty the cancellation of all responsibility on the manu-
facturer's part.
- Products that are not fitted with a rating plate must be considered anonymous and potentially dangerous.
TECHNICAL FEATURES - TECHNICAL DATA
230 (-10% +6%) V A.C.
50/60 Hz
12V D.C.
0,7 A
150W
650 N
195 N
180 mm/s
~ 2 W
- 20° C ÷ + 50° C
15%
IP40
10 m² maximum door height
(standard version) 2600 mm.
433 MHz
Yes (24V, 21W lamp)
16 Kg.
Standard version: 2600 mm.
ZKN1 - ZKN2
10 3
4
8
9
22/56
5 7
6
13
11
3
1
2
12