arjo Enterprise 9600X Notice D'utilisation page 52

The indicator lights are positioned so they can be easily seen
at a distance. A sensor (2) will automatically reduce the
brightness of the indicator lights in low light conditions, except
when an indicator light is showing an unsafe (red) condition.
When SafeSet visual status indicators are not being used, the
indicator lights can be turned off using the supplied magnetic
key fob (3). Swipe the key fob horizontally across the bottom
of the SafeSet indicator panel as shown to turn the indicator
lights off.
Once disabled the lights cannot be re-enabled within
4 seconds.
Swipe the key fob again to turn the indicator lights back on.
Fig. 32 - Turning the SafeSet indicator lights on/off
NOTE
If the bed is disconnected from the electricity supply and operated on battery power
the indicator lights will not illuminate.
When reconnected to the electricity supply the indicator lights do not automatically
illuminate. Swipe the fob to re-enable.
This is by design and is intended to conserve battery longevity.
52
3