Manual Decalcifying - Rotel AROMATICA LUXE 270 Mode D'emploi

• Press the service button (7) ca. 4 sec. The
• Empty the drip pan (9b) and slide it back in. The
bol lights up.
• Remove the water tank (17) and fill it with decalcifying liquid along with the correct
amount of water to fill it to the 0.5 l mark. (Follow the manufacturer's instructions.)
• Replace the tank. The
TIP: Place a sufficiently large receptacle (ca. 0.5 l) under the steam/hot water jet (12).
• Open the steam/hot water dial (11) by turning it clockwise.
• The coffee machine will automatically decalcify and the solution will flow through
the hot water jet (12) in intervals (ca. 10 min.). The
cess.
• As soon as the
• The decalcifying solution will now flow through the inner outlet in intervals (ca. 15 min.).
• As soon as the last of the solution has flowed through, the
• Remove the drip pan (9b) and the water tank (17) and empty everything.
• Fill the tank with fresh water and replace it as well as the pan. The
• Open the steam/hot water dial (11) by turning it clockwise.
• The system will be rinsed again through the steam/hot water jet (12) in intervals (ca.
5 min.).
• As soon as the
• The system is rinsed through the inner outlet in intervals (ca. 5 min.).
• As soon as the rinse process is done, the
• Empty the drip pan (9b) and reinsert it.
• The system will heat up briefly. The service button (7) will blink afterwards.
• Press the service button (7) and the system will be rinsed through the coffee outlet (8).
• Your coffee machine is ready for operation again.

Manual decalcifying

If you want, you may start the decalcifying program without a prior alarm showing:
• Using the on/off button (2), switch your coffee machine ON (operation mode).
• Press the service button (7) for about 4 sec. The
another.
• Wait until the
The symbol begins to blink.
• Press the service button (7) again for ca. 4 sec. The
• Continue as described above for «Empty the drip pan...»
☛
If you start the manual decalcifying program by accident, you may interrupt it
by pressing the on/off button (2) for ca. 4 sec.
32
symbol blinks.
symbol blinks again, you can close the dial (11) again.
symbol blinks again, you can close the dial (11) again.
symbol lights up and press the service button (7) briefly to confirm.
symbol blinks.
symbol blinks and the
symbol blinks during this pro-
symbol blinks.
symbols light up one after
symbol blinks.
sym-
symbols blink.
symbol blinks.