Installing The Guard Plate Holders - Stihl MH 710 Manuel D'utilisation

● Position throttle cable (1) using cable
clip (2) so that the cable is tucked away
as neatly as possible and not touching
engine components.
7.9 Installing the carrying handle
Risk of injury!
Make sure that the tiller is stable.
● Unscrew bolts (1) together with
washers (2) and nuts (3).
● Discard bolts (1), washers (2) and
nuts (3).
0478 404 8805 A - EN
● Install carrying handle (J) on the basic
unit using bolts (U3), washers (V5) and
nuts (W5).
Tightening torque: 35 - 40 Nm

7.10 Installing the guard plate holders

Installing the front right guard plate
holder
● Install front right guard plate holder (Q)
using bolts (U8) and washers (V4).
Installing the front left guard plate
holder
● Install front left guard plate holder (P)
using bolts (U8) and washers (V4).
Installing the rear guard plate holder
● Install rear guard plate holder (R) using
bolts (U10), washers (V3) and
nuts (W4).
21