Description Of Symbols - Stihl MH 710 Manuel D'utilisation

Masquer les pouces Voir aussi pour MH 710:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If the tank has to be emptied (e.g.
immobilisation before the winter break),
the fuel tank must be emptied out of doors
only (empty the tank by running the
engine, for example).
Thoroughly clean the machine before
storage (e.g. winter break).
Only store the machine with the spark plug
socket disconnected.
Store the machine in good operational
condition.
Allow the machine to cool down
completely before covering it.
4.9 Disposal
Waste products such as used engine oil or
fuel, used lubricants, filters, batteries and
similar wearing parts can be harmful to
people, animals and the environment, and
must consequently be disposed of
properly.
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products. STIHL
recommends STIHL specialist dealers.
Ensure that old machines are properly
disposed of. Read the information in the
"Environmental protection" section.
(
15.)
0478 404 8805 A - EN

5. Description of symbols

Attention! –
Risk of injury!
Read and follow the instruc-
tion manual and the safety
instructions before initial
use.
Rotating tools: Keep your
hands and feet away from
rotating tools. Only operate
with protective covers.
Keep other persons out of
the danger area.
Detach the spark plug
socket before performing
any maintenance and clean-
ing operations.
On/Off switch
The On/Off switch must be turned to I
before starting the engine.
The On/Off switch must be turned to O to
switch off the engine.
– O - Off
– I - On
Self-propulsion lever
For safety reasons, the
release lever must be
pressed before actuation of
the self-propulsion lever.
This prevents inadvertent
actuation of the self-propul-
sion lever.
Reverse drive lever
For safety reasons, the
release lever must be
pressed before the reverse
drive lever is actuated. This
prevents inadvertent actua-
tion of the reverse drive
lever.
Lateral adjustment lever
For safety reasons, the
release lever must be
pressed before the lateral
adjustment lever is actu-
ated. This prevents
inadvertent actuation of the
lateral adjustment lever.
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières