Transporting The Machine; Before Operation - Stihl MH 710 Manuel D'utilisation

Noise is produced when
working. Noise can damage the
hearing.
Wear hearing protection.

4.4 Transporting the machine

Always wear gloves in order to prevent
injuries due to sharp-edged and hot
components.
Do not transport the machine with the
engine running. Before transport, switch
off the engine, allow the work tool to come
to a complete standstill and detach the
spark plug socket.
Only transport the machine once the
engine has cooled down and with an
empty fuel tank.
Observe the information in the section
"Transport". It describes how to lift and
lash the machine. ( 14.)
Always carry the machine with two people
– use the appropriate lifting points.
Use suitable loading aids (loading ramps,
lifters).
For safety reasons, a tilt angle of 15° must
not be exceeded when transporting and
loading the machine, especially when
using loading ramps.
Secure the machine and any machine
components being transported on the load
floor using adequately dimensioned
fastening material (belts, ropes, etc.).
Never transport the machine unsecured.
STIHL recommends transporting the tiller
using a suitable trailer or on a suitable load
floor and not inside a vehicle (e.g. luggage
compartment).
0478 404 8805 A - EN
When transporting the machine, always
observe regional legislation, especially
regarding load security and the transport
of objects on load floors.

4.5 Before operation

Make sure that only persons who are
familiar with the instruction manual are
permitted to use the machine.
Check the fuel system (particularly visible
parts such as e.g. tank, tank cap, hose
connections) before operating the
machine. In the event of any leaks or
damage, do not start the engine – fire
hazard!
Have the machine repaired by a specialist
dealer prior to operation.
Observe the local regulations regarding
permitted operating times for gardening
power tools with combustion engines.
Carefully inspect the complete area on
which the machine is to be used and
remove any large stones, sticks, wires,
bones or other foreign objects which could
be thrown up by the machine.
Objects hidden in the ground (lawn
sprinkler systems, posts, water valves,
foundations, electrical wires, etc.) must be
clearly marked before working with the
machine and avoided during operation.
Never run over any such foreign objects.
All faulty, worn or damaged parts must be
replaced before using the machine.
Replace any illegible or damaged danger
signs and warnings on the machine. Your
STIHL specialist has a supply of
replacement stickers and all the other
spare parts.
Check secure seating of the spark plug
socket on the spark plug before using the
machine.
The machine must only be used in good
operating condition. Before each use,
check whether:
– The entire machine is properly
assembled.
– The safety devices (e.g. self-propulsion
lever, impact protectors, protective
covers, handlebar, protective grille) are
in good condition and working properly.
Never use the machine with missing,
damaged or worn safety devices.
– The work tools (hoes), fastening bolts
and retaining pins are fitted and are not
worn or damaged (notches, cracks).
Worn or damaged parts must be
replaced.
– The work tools (hoes) are secure and
firmly installed.
– The self-propulsion levers are working
and are easy to operate.
– The tank cap is properly attached.
– The tank and fuel-carrying parts, as well
as the tank cap are in good condition.
– The oil closure screw is properly
attached.
– The accessories used are complete
and are properly installed on the
machine. All the components included
in the scope of delivery of the accessory
must be installed/used.
Carry out any necessary work or consult a
specialist dealer. STIHL recommends
STIHL specialist dealers.
The left and right impact protectors are
adapted to the relevant working width and
must always be properly installed.
9