Installing The Guard Plate Holders; Installing The Guard Plate - Stihl MH 610 Manuel D'utilisation

● Insert screw clamp (S) into the mount at
lower handlebar (1) from below.
● Secure upper handlebar (2) with screw
clamp (S) with washers (U) and
nuts (T).
● Tighten nuts (T) so that upper
handlebar (1) can be adjusted when
opening release lever (height
adjustment) (2). (Height of end of bolt
6,5 - 7,5 mm)
20

7.9 Installing the guard plate holders

Install the front guard plate holder
● Install front guard plate holders (N, O)
together with bolt (W), washer (U) and
nut (T).
Install the rear guard plate holder
● Install rear guard plate holder (P)
together with bolt (V), washer (U) and
nut (T).

7.10 Installing the guard plate

Install the right guard plate
● Fasten right guard plate (D) to the
guard plate holders at the front and rear
using bolts (X), washers (U) and
nuts (T).
Install the left guard plate
● Fasten left guard plate (E) to the guard
plate holders at the front and rear using
bolt (X), washers (U) and nuts (T).
0478 404 8800 A - EN