Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
● Fasten lower handlebar with bolt (U7).
7.8 Installing the upper handlebar
Danger of crushing!
There is a danger of pinching when
actuating the release lever (height
adjustment).
Pay attention to moving parts!
Make sure that the cables are
positioned correctly. They must not
be knotted.
20
● 1 Press release lever (height
adjustment) (1) downwards and hold.
● 2 Insert upper handlebar (2) at lower
handlebar (3).
● Position upper handlebar (2) at centre
detent (4). Release release lever
(height adjustment) (1) and allow upper
handlebar (2) to engage.
● Insert screw clamp (K) into the mount
on lower handlebar (1) from below.
● Fasten upper handlebar (2) with screw
clamp (K) with washers (V5) and
nuts (W5).
● Tighten nuts (W5) so that upper
handlebar (1) can be adjusted when
opening release lever (height
adjustment) (2). (Height of end of bolt
6,5 - 7,5 mm)
0478 404 8805 A - EN
Publicité
Chapitres
Table des Matières
