Table des Matières
Publicité
Warning:
Do not use the apparatus when other persons are in the working area.
Do not attempt to clear a blocked nozzle or valve by blowing through using the mouth (poisoning
danger).
The appliance must be cleaned after use. When cleaning take care that water-courses are not
contaminated.
Do not drain off chemicals into other containers (bottles, cans, etc). Store equipment and chemicals in
a safe place, away from children and domestic animals.
If the apparatus is passed on to third parties, it must definitely be accompanied by this
operation manual!
Taking the apparatus into service
The sprayer may be used by instructed technicians only.
Operate the sprayer in the upright position only.
Preparation of the sprayer
Fit hose, hand-lever valve and spray wand.
As a function test, the pressure relief valve can be lifted briefly.
Filling the tank:
On each occasion first completely release the pressure in the tank by lifting the pressure relief
valve. Turn over the bow of the filling cap. Tight the filler cap firmly and remove it by giving it a
quarter turn while the same time tilting it downwards and inwards.
Fill tank with a maximum of 5 / 10, 20 litres. The remaining volume is needed as an air
cushion.
When closing the cover, make sure that the O-Ring is applied evenly around the entire tank
opening and that the locking clip is fully snapped over.
Anvendelsesområde
Apparaterne 5S, 5SI, 10S og 20S kan bruges til udbringning af:
•
Kemikalier, som er vidtgående modstandsdygtige over for opløsningsmidler
•
Kalkning
•
Forskallingsolie, mineralolie osv.
•
Alkohol baserede desinfektionsmidler, ammonium forbindelser og ammoniak
Apparatet 10SP kan bruges til udbringning af:
•
Sure rengøringsmidler i området af ca. 1 % opløsning til rengøring af gulve, vægge, facader,
metal, køretøjer og maskiner
•
Mild lud og alkali-rengøringsmidler af ca. 1 % opløsning til fjernelse af snavs- og olielag
•
Organiske syrer af ca. 5 % opløsning
•
Uorganiske syrer af ca. 1,5 % opløsning
•
Alkoholbaserede desinfektionsmidler, ammonium-forbindelser og ammoniak
Tekkniske data:
Tilladt driftstryk
Tilladt driftstemperatur
Beholderindhold
Påfyldningsindhold
Sprøjtemængde ved 6 bar
(de verstelbare straalbuis)
Sprøjtemængde ved 6 bar
(fanjet straalbuis)
Beholder
De første to cifre i fabrikationsnummeret, der er stemplet i bunden af beholderen, angiver
produktionsåret.
max. 6 bar
SP/SPI
= 30°C (86°F)
S/SI/SH = 50°C (122°F)
7,5 / 14,8 / 23,5 liter
5 / 10 / 20 liter
stråle 1,73 liter/min
forstøvning 0,65 liter/min
2,2 liter/min
Publicité
Table des Matières
