Filling The Water Reservoir; Care And Maintenance - VERITAS ALINA Mode D'emploi

After using the iron, wait until it
has cooled down and then empty
the excess water. When it has
cooled completely, wrap the cable
around the handle and attach it to
the designated hook at the front.

Filling the water reservoir

While ironing, you can control the
water level in the iron with the aid
of the two viewing windows on the
handle. If the tank is empty, it is
necessary to refill it.
1. Disconnect the plug from the
power socket.
2. Open the cover on the handle
and use the measuring cup to
pour in the required amount of
water.
3. Close the cover.
4. Insert the plug into the power
socket, wait for the light to go
out. Then you can continue
ironing.

Care and maintenance

- Before performing
maintenance, pull out the plug
and make sure the soleplate is
cold.
- The iron should not be cleaned
with cleaning
descaling agents.
- Do not hold the iron under the
running tap.
- Do not place the iron on metal
supports but on heat-resistant
surfaces.
- Empty the water tank when you
have finished ironing.
- To clean the soleplate, we
recommend
specially designed products, no
etching or abrasive substances
- Clean the plastic parts of the
iron with a damp cloth.
17
EN
any
agents or
that you use