Table des Matières
Publicité
EN
E
Pull a flexible protective tube over the full length of the
electrical cable, pass it through the vehicle floor, guide it
to the inside of the hydraulic power pack, and connect the
separate cores of the electrical cable to the electric con-
nection block foreseen on this behalf. Follow your earlier
notes on disconnecting the wiring, or follow the wiring
diagram in the annex. [See Fig. 7.6]
Fasten the electrical cable every 10cm to the vehicle
chassis and the HTL, taking into account the general pre-
scriptions for wiring fixation as mentioned in point 6
above.
DHOLLANDIA
Rys. 7.6
!
!
39
Publicité
Table des Matières
