Table des Matières
Publicité
EN
Any modifications to the mounting plates and fitting proce-
dures are strictly forbidden. No deviation is allowed with-
out prior written approval from DHOLLANDIA.
These fitting instructions aim to clarify and
teach the work method required to fit DHOL-
LANDIA HTL successfully. On numerous occa-
sions, reference will be made to the TECHNI-
CAL SUMMARY of the various lift types. These
TECHNICAL SUMMARIES contain quantified
details for each individual lift type. Some illus-
trations in these fitting instructions therefore
mention that they are an example, which
means that they don't apply to each and every
lift model covered by this handbook.
The various steps of these fitting instructions are charac-
terised by a LETTER reference above each chapter. This
to help those fitting companies that wish to split-up the
work between the different skills or specialties within the
labour force.
G
=
General guide lines
E
=
Electrical work
M
=
Mechanical work / steel plating work
F
=
Finish & anti-corrosive protection
S
=
Test and put into Service
See Annex A.2 for an overview of the principal HTL com-
ponents
DHOLLANDIA
X
13
Publicité
Table des Matières
