Table des Matières
Publicité
EN
E
When it is foreseen that the main power and earth cable
will run close to exhaust pipe, the catalyser and pre-
catalyser, the particle filter,... and other heating compo-
nents, it is compulsory to use class 2 tubing (marked
white) over the full length. This sustains a temperature of
100°C continuously, and 125°C peak.
F
E
Seek an adequate routing to run the 35mm²
(+) battery cable and (-) earth cable to the vehi-
cle battery. Ensure that the wiring cannot be
damaged, squeezed, heated or melted by any
of the fixed or moving parts of the vehicle. En-
sure also that the wiring doesn't interfere with,
or isn't connected or attached to the suspen-
sion, the breaking systems, oil pipes and wiring
circuits of the vehicle. Ensure adequate fixation
by means of cable ties every 10 cm. [See Fig.
6.4]
E
The 35mm² (+) battery cable and (-) can be
fixed the chassis by means of cable ties around
existing holes or cavities in the chassis [See
Fig. 6.4], or by means of wire clips riveted or
bolted to the chassis, and sufficiently protected
against corrosion by means of zinc spray, Dini-
trol,... (refer to the manufacturer's handbook for
details what is allowed and not allowed).
Seek an adequate entry into the driver's cabin or the bat-
tery compartment under the motor hood. Most vehicle
brands and types are equipped with a dedicated rubber
diaphragm to pass the wiring from the chassis area to the
inside of the vehicle cabin (without drilling extra holes).
[See Fig. 6.5]
DHOLLANDIA
Rys. 6.4
EX.
!
EX.
Rys. 4.12
!
EX.
Rys. 6.5
29
!
!
!
!
Publicité
Table des Matières
