Parkside PAT 20-Li A1 Traduction De La Notice Originale page 41

˜ Operation
˜ Stapling/Nailing
(Fig. H)
1. Press down the safety contact
the workpiece.
2. Hold the handle
product firmly aligned with the work
surface before firing. This ensures the
complete penetration of the staple
or nail.
3. Pull the trigger
2 ] [
product against the workpiece.
NOTE
Do not trigger the product when the
u
magazine is empty to prevent
[ 7 ]
excessive wear.
˜ Switching the LED work light
on/off
(Fig. H)
While holding the handle
o
hold the on/off switch
the LED work light
Release the on/off switch to switch off
o
the LED work light.
˜ Setting the impact force
NOTE
Select the lowest impact force that
u
is su cient for fastening works to
avoid over driving or damaging the
materials to be fastened.
onto
[ ]
and keep the
4 ] [
while holding the
, press and
4 ] [
to switch on
3 ] [
.
[ ]
Increasing the impacting force:
o
Turn the impact force control
a clockwise direction (towards the
+ marking).
Decreasing the impacting force:
o
Turn the impact force control in a
anti-clockwise direction (towards the
– marking).
If the impact force is set correctly, the
o
crown of the staple or head of the nail
is ush with the fastened material.
in
[ 1 ]
GB/IE 39