Parkside PAT 20-Li A1 Traduction De La Notice Originale page 39

If you are not certain ask a qualified
o
specialist and get advice from your
trusted dealer.
WARNING!
m
Do not use accessories not
u
recommended by Parkside. This may
result in electric shock or fire.
˜ Charging the battery pack
(Fig. C)
CAUTION!
m
Always disconnect the mains
u
plug before removing the battery
pack from the charger
[ ]
before connecting it to the charger.
NOTE
Initially, the battery packs are
u
partially charged. Charge the battery
pack completely before first use.
The battery pack can be charged
u
at any time as needed without
shortening its service life.
Interrupting the charging process
u
does not damage the battery pack.
Never charge the battery pack if the
u
ambient temperature is below +4 °C
or above +40 °C.
1. Insert the battery pack into
the charger.
2. Connect the mains plug to a suitable
socket-outlet.
The charging control LEDs (green
o
and red ) indicate the charging
[ ]
status of the battery pack:
LED
Red LED lights
up
and
[ ]
[
Status
Battery pack is
charging
LED
Green LED lights
up
Green and red
LED ashing
Red LED ashing Battery pack is too
Green LED lights
up (without
battery pack)
When the battery pack is fully charged:
1. Disconnect the mains plug from the
socket-outlet.
2. Remove the battery pack from
the charger.
˜ Checking the battery pack's
charging level
(Fig. B)
Press the
o
level LEDs
Charging level LEDs
Red/orange/green
Red/orange
Red
NOTE
When the charging level is below
u
30 charge the battery pack
˜ Attaching/removing the
]
battery pack
(Fig. D)
Attaching the battery pack
Insert the battery pack
o
battery port
Status
Battery pack fully
charged
Battery pack is
defective
cold or too warm
Charger is ready to use
button . The charging
[ ]
light up:
[ ]
Charging level
0
30–70
30
into the
[ ]
until it clicks into place.
5 ] [
GB/IE
.
[ ]
37