Publicité
- Option D - Charging using the vehicle socket and optional
ProCharger charger plug:
Disconnect the charger plug from the vehicle socket on your
motorcycle.
Interrupting the charging process
The charging process can be interrupted or ended at any time. To
do this, the charger must always be disconnected from the mains
(by pulling out plug), then disconnected from the battery.
Charging duration
Please bear in mind that the charging time can vary, depending on
the battery capacity or residual capacity.
11 | Quick connector
You can use the ProCharger quick connector to connect charger
clamp cables, ring terminal cables and other compatible ProCharger
accessories to the ProCharger charger. To do so, both parts of
the quick connector are joined together until they snap into place.
The plug-in connector on the quick connector is reverse polarity
protected and can only be connected in one position.
To disconnect this connection, you have to actuate the red rocker
0020145_ProCharger_Lithium_ANL_18.indd 47
• Thoroughly read the instructions for use before using the
ProCharger 1.000 Lithium. It is imperative that you adhere
to the instructions of the vehicle and battery manufacturer.
• The "trickle charging" program is only run once every 24
hours, during which the battery is recharged up to 14.3 V.
47
20.07.18 12:01
Publicité
