Publicité
- Option D - Charging using the vehicle socket and optional
ProCharger charger plug:
Connect the charger plug cable to the charger using the quick
connector (if you have not already done so). Insert the charger plug
into the socket on your motorcycle. However, this only works if the
socket is connected directly to the battery. If it is connected via the
electrical system, charging will not be possible because the charger
does not have a CAN bus charging function that enables the power
socket for charging.
• Now connect the battery charger to the mains power. The
• The rechargeable battery is fully charged when the "Battery fully
• After the charging process, first disconnect the charger from the
• It is imperative to adhere to the following disconnection sequence:
- Option A - Charging the battery with the charging clamp cable while
installed:
First disconnect the black charging clamp (minus) from the vehicle
chassis or the engine block. Then, disconnect the red charging
clamp (plus) from the positive terminal on the battery.
- Option B - Charging the battery with the charging clamp cable while
removed:
First disconnect the black charging clamp (minus) from the negative
terminal on the battery. Then, disconnect the red charging clamp
(plus) from the positive terminal on the battery.
- Option C - Charging with the ring terminal cable:
Disconnect the charger from the ring terminal cable using the
quick connector and close the ring terminal cable socket with the
enclosed fastener.
46
0020145_ProCharger_Lithium_ANL_18.indd 46
"Mains" LED indicator
charged" LED
mains power.
lights up.
lights up constantly.
20.07.18 12:01
Publicité
