Publicité
• Make sure that the charger is initially not
• It is imperative to adhere to the following
- Option A - Charging the battery with the charging clamp cable while
installed:
Connect the charging clamp cable to the charger using the quick
connector (if you have not already done so). Then, first connect the
red charging clamp (plus) to the positive terminal on the battery.
After doing so, connect the black clamp (minus) to the vehicle
chassis or the engine block, but not in the vicinity of the battery,
the fuel supply line or the carburettor, and not to metal clips or
moving parts.
(The black (minus) terminal of the charger is connected to the
vehicle chassis or the engine block in accordance with the EN
standard, i.e. a little distance away from the battery. This prevents
explosive gases which may be in the direct vicinity of the battery,
from igniting due to sparks on the
battery terminal.)
- Option B - Charging the battery with the charging clamp cable while
removed:
Connect the charging clamp cable to the charger using the quick
connector (if you have not already done so). Then, first connect the
red charging clamp (plus) to the positive terminal on the battery.
Then, connect the black clamp (minus) to the negative terminal on
the battery.
- Option C - Charging with the ring terminal cable:
First disconnect the motorcycle earth connection from the battery.
Then, screw the red ring connector (plus) of the ring terminal cable
on the battery's positive terminal. Next, screw the black ring terminal
(negative) of the ring terminal cable and the motorcycle's earth
connection to the battery's negative terminal again. Finally, connect
the ring terminal cable to the charger using the quick connector.
0020145_ProCharger_Lithium_ANL_18.indd 45
connected to the mains socket.
connection sequence:
45
20.07.18 12:01
Publicité
