Publicité
EN
4.14 - Resetting the factory parameters
To reset all the parameters to their default values or to change the type of equipment on which the control unit is installed, proceed as
follows:
1. Press and hold the
2. Scroll through the menu items using the
3. Press and hold the MENU button; release the button when the display starts flashing; the number displayed indicates the type of
motor in use.
4. Use the
(UP) and
The display shows a countdown from 50 to 0; release the button when
5. The control unit exits the MENU after seven seconds of inactivity or by briefly pressing the
WARNING
if the motor type is changed, all the values are taken back to the default values and it will be necessary to carry out a
new auto-learning procedure of the stroke.
4.15 - System customisation
The configuration menus of the equipment's operating functions are divided into BASE and ADV (basic/advanced). The following tables
show the description of each basic parameter with their respective minimum, maximum and predefined values.
1. Press and hold the
access the basic menu.
2. Scroll through the menu items using the
3. Press and hold the
4. To change the value, use the
button until the display stops flashing
5. To exit the menu, briefly press the
NOTE: to display the value of any parameter, simply enter the relative menu (BASE or ADV) using steps 1 and 2 of the procedure
described above. Once the desired parameter has been identified, the display will alternately show the parameter name and the
value. To exit the menu, briefly press the
4.16 - Basic Parameters
PARAMETERS
1
2
3
4
5
6
7
40
(MENU) button; the display will show, in sequence,
(UP) and
(DOWN-RADIO) buttons to select the type of motor; press and hold the
(MENU) button; the display will show, in sequence,
(UP) and
(MENU) button until the display flashes; release the
(UP) and
(DOWN-RADIO) buttons; to confirm the new value, press and hold the
(MENU) button
(MENU) button
DESCRIPTION
Automatic re-closing time (0 = off)
Re-closing time after transit on PH1 (0 = off)
Sensitivity to obstacles
0 = maximum impact force
10 = minimum impact force
Leaf speed during opening
1 = minimum speed
5 = maximum speed
Leaf speed during the slow-down phase when opening
1 = minimum speed
5 = maximum speed
Leaf speed during closing
1 = minimum speed
5 = maximum speed
Leaf speed during the slow-down phase when closing
1 = minimum speed
5 = maximum speed
; release the key at the word ADV.
(DOWN-RADIO) buttons until you reach
appears.
and
(DOWN-RADIO) buttons until you reach the desired parameter
(MENU) button
button.
(MENU) button
, release the key at the word
DEFAULT
MIN
MAX
0
0
900
0
0
30
3
0
10
4
1
5
1
1
5
4
1
5
1
1
5
to
(MENU)
UNIT
s
s
Publicité
