Publicité
4.12.1 - Autolearning of the travel stroke and main parameters
1. Unlock the gear motors, bring the leaves to approximately half way and lock the
gear motors again.
2. To start the auto-learning procedure, simultaneously press and hold the
buttons; after about two seconds, the leaf relating to M1 starts to open slowly; the display shows
WARNING
If the leaf moves in the closing direction, interrupt the movement by pressing the
(DOWN) button; press the SBS button resume the auto-learning procedure with reversed direction of
travel.
3. Once the maximum opening point has been reached, the leaf relating to M1 stops; the leaf relating to
M2 starts opening slowly; the display shows
WARNING
If the leaf moves in the closing direction, interrupt the movement by pressing the
(DOWN) button; press the SBS button resume the auto-learning procedure with reversed direction of
travel.
4. Once the maximum opening point has been reached, the leaf relating to M2 stops; after about 2
seconds, it starts closing slowly; the display shows
5. The auto-learning operation of the stroke of the leaf relating to M2 stops when the closing point has
been reached. After about two seconds, the leaf relating to M1 starts closing slowly; the display shows
6. The auto-learning operation of the stroke of the leaf relating to M1 stops when the
closing point has been reached. The auto-learning operations are finished.
WARNING
The auto-learning operations of the stroke must be completely finished before the
equipment is put into operation; they can only be interrupted by intervening on the safety devices
(EDGE/STOP, PH2, PH1) or by disconnecting the control unit from the power supply.
7. After having correctly completed the auto-learning procedure, carry out some complete opening and
closing manoeuvres of the gate to check that it is working properly.
After successfully completing the auto-learning procedure, it will be possible to change the operating parameters by accessing the
and/or
parameter menu.
4.12.2 - Autolearning of the travel stroke and main parameters, with customised decelerations
The default low-speed stroke length is 20% of the total stroke length. It is possible to change the default value of the low-speed
stroke length, both during opening and closing, by adjusting the
(custom).
1. Unlock the gear motors, bring the leaves to approximately half way and lock the gear motors again.
2. To start the auto-learning procedure, simultaneously press and hold the
buttons for about two seconds; after about two seconds, the leaf relating to M1 starts to open slowly;
the display will show
WARNING
If the leaf moves in the closing direction, interrupt the movement by pressing the
(DOWN) button; press the SBS button to resume the auto-learning procedure with reversed direction
of travel.
3. Once the maximum opening point has been reached, the leaf relating to M1 stops; the leaf relating to
M2 starts opening slowly; the display shows
WARNING
If the leaf moves in the closing direction, interrupt the movement by pressing the
(DOWN) button; press the SBS button to resume the auto-learning procedure with reversed direction
of travel.
4. Once the maximum opening point has been reached, the leaf relating to M2 stops; after about 2
seconds, it starts closing slowly; the display shows
5. Having reached the point at which it is necessary to start the slow-down phase (during closing), press
the
(SBS) button; the display will show
6. The auto-learning operation of the stroke of the leaf relating to M2 stops when the
closing point has been reached. After about two seconds, the leaf relating to M1 starts closing slowly;
the display shows
(UP) and
.
.
parameter in the
(UP) and
.
.
(MENU)
M1
M1
M1
M1
menu by selecting P
(MENU)
M1
M1
M1
EN
M2
M2
M2
M2
M2
M2
M2
37
Publicité
