Publicité
EN
4.11.1 - Display error messages
To delete the error message on the display, after eliminating the cause of the fault, carry out a complete opening or closing manoeuvre,
i.e. until the relative limit switch has been reached. Alternatively, briefly press the MENU button (the automation does not perform any
movements).
MOTOR OVERLOAD
SAFETY EDGE
PHOTOCELL TEST
ENCODER
4.11.2 - Flashing light error messages
The events indicated in the following table are reported by the flashing light and the KEY LED on the control unit.
INDICATION OF FLASHING LIGHT AND
KEY LED ON THE CONTROL UNIT
2 fast flashes + pause + 1 flash
4 fast flashes + pause, 3 times
2 fast flashes + pause, 3 times
5 fast flashes + pause, 3 times
3 fast flashes + pause, 3 times
6 fast flashes + pause, 3 times
7 fast flashes + pause, 3 times
4.11.3- Display status messages
By repeatedly pressing the
To go back to the normal state, press the
DISPLAY
,
I M1= 1200
I M2= 1200
CT20324 – FW 2.0 – SN 635A33F1
4.12 - Autolearning of the travel stroke
When the equipment is switched on for the first time or if the model
is changed, which involves resetting it to the factory settings, the
message
learning procedure for the operating parameters will have to be
carried out (leaf movement angle width, slow-down points during
opening and closing, ...).
36
(UP) button, the additional information described in the following table appears on the display.
(MENU) button
,
,
, ecc.
will appear on the display and the auto-
The current of a motor has increased very quickly
1. The gate has hit an obstacle
2. Excessive friction in the leaf movement
The control unit has detected the activation of the safety edge
1. The safety edge is active
2. The safety edge is correctly connected
The photocell or safety edge test has failed
1. Check that the photocells are working properly
2. Check the photocell connections
The physical encoder is not responding
1. Check that the encoder is working properly
2. Check that the encoder is correctly connected
EVENT
auto-learning
Obstacle detected
Photo1 / Photo2
Safety edge
Photo test failed
Overload
short circuit
Encoder Error
MEANING
Automation status
Total number of complete opening + closing manoeuvres
Instantaneous current absorbed by motor M1, given in mA
Instantaneous current absorbed by motor M2, given in mA
Board type – firmware version – board serial number
WARNING
learning procedure (
parameters).
DESCRIPTION
Auto-learning phase in progress
A leaf has hit an obstacle
A photocell has been activated
The safety edge has been activated
Photocell or sensitive edge test failed
Fault in one of the outputs
FLASH, ELS/SCA or LED
Motor M1 or M2 encoder fault
Select the correct motor before starting the auto-
paragraph 4.17 - Advanced
Publicité
