Publicité
EN
7. Having reached the point at which it is necessary to start the slow-down phase (during closing), press
the
(SBS) button; the display will show
8. The auto-learning operation of the stroke of the leaf relating to M1 stops when the
closing point has been reached.
After about 2 seconds, the leaf relating to M1 starts opening again; the display shows
9. Having reached the point at which it is necessary to start the slow-down phase while opening the leaf
relating to M1, press the
10. Once the maximum opening point has been reached, the leaf relating to M1 stops; then the leaf
relating to M2 starts opening; the display shows
11. Having reached the point at which it is necessary to start the slow-down phase while opening the leaf
relating to M2, press the
12. Once the maximum opening point has been reached, the leaf relating to M2 stops; then the
closing manoeuvre of both leaves is carried out. When both leaves have reached the closing
position, the auto-learning procedure of the stroke with customised slow-down points is completed.
WARNING
If, during the various opening/closing manoeuvres, one of the slow-down points is
not set, it will be automatically set to 20% of the total stroke length.
WARNING
The auto-learning operations of the stroke must be completely finished before the
equipment is put into operation; they can only be interrupted by intervening on the safety devices
(EDGE/STOP, PH2, PH1) or by disconnecting the control unit from the power supply.
13. After having correctly completed the auto-learning procedure, carry out some complete opening and
closing manoeuvres of the gate to check that it is working properly.
After successfully completing the auto-learning procedure, it will be possible to change the operating parameters by accessing the
and/or
parameter menu.
4.13 - Radio remote control management
For the memorisation of the buttons of a radio remote control, their
deletion or the deletion of all memorised radio remote controls, use
the
To access the
the
(DOWN) button for about two seconds; the display will show
the text
NOTE: the control unit exits the
of Inactivity or by briefly pressing the
4.13.1 - Memorisation of buttons of a radio remote control
1. Exit any menu, press and hold the
alternately shows
2. Briefly press the
(DOWN) button a number of times equal to the number of the function to be
selected. The available functions are:
Press once for
(open bistable)
NOTE: the preset function (5) allows all 4 buttons of a radio remote control to be memorised at once
with the functions: button 1 = SBS, button 2 = PAR, button 3 = OPEN, button 4 = LIGHTS.
NOTE: if the courtesy lights are activated from the radio remote control, they can only be deactivated
from the radio remote control.
3. Immediately after pressing the
(short flashes) corresponding to the selected function, interrupted by a pause of about one second.
4. Near the control unit, within seven seconds, press the button on the radio remote control to be
associated to the selected function; keep the radio remote control button pressed for a few seconds.
NOTE: for the preset function (5), press any button
38
(SBS) button; the display will show
(SBS) button; the display will show
menu, press and hold
menu after seven seconds
(MENU) button
(DOWN) button until the display
(step-by-step), press twice for
(DOWN) button, the KEY LED flashes a certain number of times
NOTE: to facilitate the memorisation operations, minimising
any interference, the receiver's antenna wire should be
disconnected; therefore the procedure only works near the control
unit itself.
WARNING
Once the operations are complete, reconnect the
control unit receiver's antenna wire.
(open), press 3 times for
M1
M2
M1
M2
M1
M2
M1
M2
M1
M2
►
►
►
►
+1s
+1s
2 s
Publicité
