Publicité
5. A long flash (about three seconds) of the KEY LED will confirm correct memorisation.
If the KEY LED emits a series of short flashes, the radio remote control button you are
WARNING
attempting to memorise is already present in the memory.
NOTE: after having memorised the radio remote control button, within seven seconds, it is possible to
associate another button of the same radio remote control or any button of another radio remote control
with the same function, by repeating the operations from step 3.
4.13.2 - Deletion of a memorised button of a radio remote control
Exit any menu, press and hold the
alternately shows,
1. Press and hold the
(DOWN-RADIO) button until the KEY LED lights up;
release the button.
2. Within seven seconds, press and hold the radio remote control button to be deleted
from the receiver's memory until the KEY LED starts flashing; release the button.
3. Confirm the deletion of the radio remote control by pressing the
4. A long flash of the KEY LED will indicate that the radio remote control has been successfully deleted.
5. The control unit exits the
4.13.3 - Deletion of the entire receiver memory
Exit any menu, press and hold the
.
1. Press and hold the
(DOWN-RADIO) button until the KEY LED lights up (about three
seconds); keep holding the
2. After releasing the button, the KEY LED will start flashing slowly; count the flashes.
3. When it flashes for the third time, briefly press the
4. A long flash of the KEY LED will indicate that all radio remote controls have been deleted.
5. The control unit exits the
4.13.4 - Memorisation of a button of a new radio remote control unit using a radio remote control already in
the memory
It is possible to add the button of a new radio remote control to a control unit in which at least one radio
remote control has already been memorised
1. Near the control unit, press and hold for at least five seconds the button of the
new radio remote control to be added to the control unit
2. Near the control unit, press and hold for at least three seconds the button of the
already memorised radio remote control with which the function to be duplicated on the new radio
remote control
is associated.
NOTE: if step 1 has been performed correctly, the automation will not carry out any manoeuvres and it
will be possible to proceed with memorisation.
3. Near the control unit, press and hold for at least three seconds the same button
of the new radio remote control used in step 1.
4. Near the control unit, press and hold for at least three seconds the same button
of the old radio remote control used in step 2.
NOTE: the procedure has been correctly carried out if the automation executes the command just
memorised.
If the procedure is not completed, after a few seconds, the control unit receiver will return to normal
operation.
(DOWN-RADIO) button until the display
.
after seven seconds of inactivity or by briefly pressing the button
(DOWN-RADIO) button until the display alternately shows
(DOWN-RADIO) button until the KEY LED goes out; release the button.
(DOWN-RADIO) button.
after seven seconds of inactivity or by briefly pressing the button
(DOWN-RADIO) button
EN
>3s
►
(3s)
►
3s
►
►
►
►
+3s
(3s)
(3s)
(3s)
39
Publicité
