Parkside PWSA 12 B1 Traduction Des Instructions D'origine page 37

Special safety instructions for
grinding and cutting
a) Use only grinders which have
been approved for your electric
tool and the protective hood
intended for these grinders.
Grinders which are not intended
for the electric tool may not be
sufficiently shielded and are un-
safe.
b) Depressed Center grinding
wheels must be pre-assembled
so that their surface not above
the level of the edge of the
guard stands out. An improperly
mounted grinding wheel, which
extends beyond the level of the
edge of the guard, not sufficient-
ly shielded.
c) The protective hood must be
securely attached to the elec-
tric tool and adjusted so that
the greatest level of safety is
reached, i.e., the smallest pos-
sible amount of the grinder is
exposed to the operator. The
protective hood should protect
the operator from broken bits
and accidental contact with the
grinder.
d) Grinders may only be used for
the recommended attachment
options. For example: Never
grind with the side surface of
a cutting disc. Cutting discs
are for cutting material using
the edge of the disc. Pushing
sideways on these grinders can
break them.
e) Always use undamaged clamp-
ing flanges of the correct size
and shape for the grinding disc
you selected. Suitable flanges
support the grinding disc and
thus reduce the danger of the
grinding disc breaking. Flanges
for cutting discs can be distin-
guished from flanges for other
grinding discs.
f) Do not use worn grinding discs
for larger electric tools. Grind-
ing discs for larger electric tools
are not set up for the higher ro-
tation speeds of smaller electric
tools and can break.
Other special safety instruc-
tions for cutting grinding
a) Avoid blocking the cutting disc
or pressing down too hard. Do
not make any excessively deep
cuts. Overloading the cutting
disc increases wear and its ten-
dency to tilt or block and, with
that, to kickback or break the
grinder.
b) Avoid the area in front of and
behind the rotating cutting disc.
When you move the cutting disc
by itself in the workpiece, in the
GB IE
37