Publicité
ENGLISH
CONNECTION TO THE GAS SUPPLY
Warning: This appliance has been tested in accordance with the following standards:
• Household Cooking Gas Appliances [ANSI Z21.1:2018 ]
• Household Cooking Gas Appliances [CSA 1.1:2018 ]
• Gas-fired appliances for use at high altitudes [CSA 2.17-2017]
• It is the responsibility of the owner and the installer to determine if additional require-ments, such as local codes
and/or stan-dards, apply to specific installations. In the absence of local codes, the installation must conform with
the National Fuel Code, ANSI Z223.1/NFPA54.
For Massachusetts Installations
1. Installation must be performed by a qualified or licensed contractor, plumber or gas fitter qualified or licensed
by the state, province or region where this appliance is being installed.
2. Shut-off valve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer than 36 inches.
• Installer show the owner where the gas shut-off valve is located.
High Altitude Installation note
• This cooker is ETL certified for safe operation up to an altitude of 2000 ft without any modifications. For altitudes
between 2000-4500, please contact with Service and request conversion with high altitude injector kit. This product
is not intended to be used for altitudes higher than 4500 ft.
Warning: THE CONVERSION SHALL BE CARRIED OUT BY A MANUFACTURER'S AUTHORIZED REPRESENTATIVE, IN ACCORDANCE
WITH THE REQUIREMENTS OF THE MANUFACTURER, PROVINCIAL, OR TERRITORIAL AUTHORITIES HAVING JURISDICTION AND
IN ACCORDANCE WITH THE REQUIREMENTS OF THE CSA B149.1 OR CSA B149.2 INSTALLATION CODES .
Connect to the gas supply
Warning: This product can be converted to LP Gas. Gas convertion must always be performed by Authorized Service Agents.
• The gas connection is located below the back panel of the range. It is accessible back of the range.
• Shut off main gas supply valve before discon-necting the old range and leave it off until the new hook-up has been completed.
• The cooker can be installed using rigid pipe or a CSA, cCSAus, UL International-certified flexible metal appliance connector.
If using a flexible connector, always use a new connector.
• Apply pipe joint compound or tape appropriate for use with Natural gas around all male pipe threads to prevent leaks.
• If not already present, install gas shut off valve in an easily accessible location. Make sure all users know where and how to
shut off the gas supply to the range.
•Gas supply pressure for checking the regulator setting is 6" WC.
Caution: The installer should inform the consumer of the location of the gas shut-off valve.
5
Publicité
