Publicité
ENGLISH
Flexible Connector Method
1. Install male 1/2" flare adaptor at the 1/2" NPT internal thread of the range inlet. Use a backup wrench on the elbow fitting
to avoid damage.
2. Install male 1/2" or 3/4" flare union adapter on the NPT internal thread of the manual shut-off valve.
3. Connect flexible metal appliance connector.
4. Make sure circuit breaker is off and then plug range cord in to electrical outlet.
5. Push range back into position insuring that range leg slides under the anti-tip bracket. The range will sit 3/4" away from the
wall when properly installed.
Warning: Be careful not to crimp flexible connector!
6.Carefully tip range forward to insure that anti-tip bracket engages and prevents tip-over.
Rigid Pipe Method
• The configuration of the rigid pipe connection will vary depending on the location of the gas pipe stub. Refer to Figure below
for details.
1. Make sure circuit breaker is off and then plug range cord in to electrical outlet.
2. Push range back into position insuring that range leg slides under the anti-tip bracket. The range will sit 3/4" away from the
wall when properly installed.
3. Carefully tip range forward to insure that anti-tip bracket engages and prevents tip- over.
4. Connect pipe to range at union. Access the connection through the access panel behind the warming drawer. Proceed to
Test for Gas Leaks.
6
Publicité
