Publicité
ENGLISH
REPLACING THE BAKE AND BROIL ORIFICE
Bake Burner
1. Open and remove the oven door. Remove the two screws at the back of the oven floor (FIG A, B). Lift up on the back of the
floor panel, slide backwards and lift out to remove it.
FIG A
2. Remove the burner front shield shown in FIG C by removing the front two (2) Philips head screws indicated with the red
arrows and the rear two (2) Philips head screws (One on each side) as shown in (FIG D) below.
FIG C
3. With the shield removed, remove the 7mm screw that holds the burner secure in the front as shown in (FIG E). Remove the
Philips head screw from the brass strain relief cover shown in (FIG F) and place to the side.
FIG E
4. Gently lift the burner up from the front, then pull forward to expose the bake orifice shown in (FIG G). Remove the NAT gas
orifice using a 7mm nut-driver or socket as shown in (FIG H). Install the LP orifice "K" from the conversion kit.
FIG B
FIG D
FIG F
15
Publicité
