Publicité
ENGLISH
SNESSLINGE adjustment Screw Access
3. You will now see the spark switch. In the bezel, there is an access hole that allows the 3/32nd screwdriver to access the
adjust screw on the valve by a square access hole in the spark switch. FIG D shows the screwdriver through the bezel while
FIG E shows a close-up of the screwdriver going through the spark switch. FIG F shows the adjustment screw with the bezel
FIG D
4. Place the knob back on the gas tap shaft and ignite the burner. Turn the gas top on to the simmer position. FIG G shows
the flame before the adjustment. Now, turn the adjustment screw CLOCKWISE until you feel resistance, then stop. The flame
will be reduced to the proper level shown in (FIG H).
FIG G
Caution: Make sure that after you make the adjustment, turn the burner OFF, then back on to lite and turn to simmer to make
sure the flame stays lite. If not, adjust setting until correct.
Make the same adjustments to all other single burners.
FIG E
FIG H
FIG F
13
Publicité
