Publicité
ENGLISH
FIG G
5. Reinstall burner assembly, brass strain relief, front burner shield and bottom oven floor.
Warning: Make sure that when reinstalling the burner it is positioned in a way that the orifice is inside the burner tube and
centered properly. Failure to properly position the burner could cause poor ignition or explosion from flashback.
Broil Burner
1. Remove the Philips head screw from the brass strain relief cover shown in FIG A and set a side. Remove the Phillips head
screw shown in FIG B that holds the burner in place.
FIG A
2. Pull the burner down and forward to expose the roil orifice shown in FIG C. Remove the NAT gas orifice using a 7mm
nut-driver or socket as shown in FIG D. Install the LP orifice "J" from the conversion kit.
FIG C
16
FIG H
FIG B
FIG D
Publicité
