Publicité
ENGLISH
4. Reinstall the cap and tighten, then place the red cap over the pin as shown in FIG F. The regulator has now been converted.
Reconnect the red cap. The regulator has been successfully converted.
FIG F
REPLACING THE SURFACE ORIFICES
Note: The instructions in the manual are for the "all gas units SNESSLINGE, but the instructions still apply to the surface
orifices on the SNESSLINGE.
1. Remove all burner grates, burner caps and burner bases as shown in FIG A. FIG B shows all the surface components
removed.
FIG A
2. Convert the center burner (Dual Burner) first. There are three (3) orifices that must be changed on this burner. First change
the center orifice, shown in FIG C. Be sure to use the orifice marked "D", shown on the orifice card in FIG D.
FIG C
D
Be sure to place the NAT orifices you remove during the conversion process back into the orifice card in their proper positions.
This will ensure proper orifice replacement should the range need to be converted back to Natural Gas.
Warning: After the above operations are complete, check to ensure that there is NO gas leakage.
10
FIG G
FIG B
FIG D
Publicité
