Publicité
ENGLISH
TOOLS REQUIRED TO CONVERT RANGE
Warning: Gas conversion operations must be carried out by a qualified and authorized installer, service agency, plumber,
licensed contractor, gas fitter or gas supplier as required by the state, commonwealth or region where this appliance is
being serviced. The gas conversion must conform with these instructions and with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in Canada, the Natural Gas and Propane Installation Code,
CSA B149.1. The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of
local codes, with the Notional Electrical Code, NFPA 70 or the Canadian Electrical Code, CSA C22.1-02. Beko is not responsible
for any damage that may occur due to failure to follow the instructions in this Guide or the regulations for your area.
IMPORTANT SAFETY INFORMATION
Warning: (Fire/Explosion Hazard) If the information in this guide is not followed exactly, a fire or explosion may result causing
property damage, personal injury or death.
• What to do if you smell gas:
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from a neighbor' s phone. Follow the gas supplier' s instructions.
• If you cannot reach your gas supplier, call the Fire Department.
Caution: Be sure the electric power is turned off at the breaker box while the unit is being converted.
Caution: Before placing the appliance into operation, always check for gas leaks with a soapy water solution or other
acceptable method. DO NOT use an open flame to check for leaks.
Caution:DO NOT forget to wear protective gloves during the gas conversion process .
8
7 mm Box Wrench
7 mm Socket or Driver
3/32nd X 21/2 Flat Blade Screwdriver
Small Adjustable wrench
#1 and #2 Phillips Head
Publicité
