Publicité
ENGLISH
FIG H
C
D
On the SNESSLINGE models, this procedure will be done to the left front and right front burners, each needing all three (3)
Orifices replaced! On the Slide-In models, only the right front has the dual burner.
6. Repeat these steps on the remaining surface burners, replacing the NAT orifices with the LP orifices according to the orifice
card.
A
Rear Left
B
Rear Right
C/C/D
Center
E
Front Left
F
Front Right
G
Broiler
H
Oven
ADJUSTING THE LOW FLAME SETTINGS
Warning: After the operations are complete, check to ensure that there is no gas leakage.
1. With all the surface burner orifices changed, the next step is to adjust the low flame settings on all the surface burner gas
valves. All standard burners have one (1) adjustment screw while the Dual Burners have two (2) low flame settings.
2. To adjust the low flame setting on the single burners, remove the knob (FIG A), spring (FIG B) and washer (FIG C) and set
aside.
FIG A
Caution: If you are working on an SNESSLINGE models, proceed to Step 3.
12
FIG I
C
FIG B
FIG C
Publicité
