Publicité
V1.0
4.
Discontinue use if a power cord feels more than comfortably warm while
operating the tool.
5.
Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch the plug or wiring with wet hands.
6.
Prevent damage to the power cord by observing the following:
a.
Place the power cord in a position that prevents it from coming into
contact with the tool or getting caught by the workpiece. The cord
should always stay behind the tool.
b.
Do not pull on the cord to disconnect the plug from an outlet.
c.
Keep the cord away from heat, oil, sharp edges or moving parts.
7.
Position the cord so it is not stepped on, tripped over or otherwise
subjected to damage or stress.
8.
Do not allow people, mobile equipment or vehicles to pass over unprotected
power cords. Position power cords away from high traffic areas.
a.
Place cords in reinforced conduits or place planks on either side of
the power cord to create a protective trench.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make
sure that all items in the contents are included.
Contents:
U1 Jointer
U2 Fence
U3 Fence support
assembly
U4 Fence sliding base
U5 Spring
U6 Hex wrench, 4 mm
U7 Locking handle
U8 Flat washer
U9 Square nut
U10 Filter bag
Visit www.princessauto.com for more information
Benchtop Jointer
U11 Dust chute
U12 Push Block
U13 Push Stick
9276635
9
Publicité
