Publicité
9276635
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Motor will not
start.
Motor starts
slow and
doesn't reach
operation
speed.
Tool is making
unusual
sounds.
22
Benchtop Jointer
Possible Cause(s)
1. Supplied power is
interrupted.
2. Fuse or breaker
tripped.
3. Motor components are
short-circuiting or are
defective.
4. Motor has overheated.
5. Extension cord or
power supply cord is
damaged.
1. Voltage is too low.
2. Motor is damaged.
3. Extension cord is too
long or wire gauge is
too thin.
1. The jointer' s parts may
be rubbing or binding.
2. Electrical components
may be shorting.
3. Worn tool components
Suggested Solution(s)
1. Check that power supply is
still available.
2. Replace fuse or reset breaker.
3. Have a qualified technician
service the tool.
4. Allow motor to cool before
attempting to use.
5. Replace damaged power
cord.
1. Confirm power source amps
and voltage matches or
exceeds those of . Remove
other tools or devices on the
same electrical circuit.
2. Have a qualified technician
service the tool.
3. Eliminate the use of an
extension cord. If an
extension cord is needed, use
one with the proper diameter
for its length and load.
1. Check for obstructions or
misaligned tool components.
Lubricate, repair or replace
the components based on the
particular problem.
2. Disconnect tool from the
power source immediately.
Have the tool examined by a
qualified technician.
For technical questions call 1-800-665-8685
V1.0
Publicité
