Publicité
ENGLISH
22
The push stick or the handle for a push stick should
always be stored on the machine when not in use.
WARNING: Do not use protective devices for the
purpose of transport/lifting.
Replace the worn table insert.
Use a push stick for straight cuts of small workpieces
against the rip fence.
When transporting the power tool, the blade guard
must be in the lowest position, close to the table.
When making mitre cuts with the table tilted, place
the rip fence on the lower part of the table.
When cutting round or irregularly shaped wood, use
a suitable holding device to prevent the workpiece
from twisting.
Warning! Never use the cutting guard for lifting or
moving.
Adjust the adjustable guards so that they are as close
as possible to the workpiece.
Avoid abnormal body positions.
Make sure you have a secure footing and
keep your balance at all times. This will enable
you to control the power tool better in unexpected
situations.
Mains connection
Operation is only permitted with a residual
current circuit breaker (RCD max. residual .
Only connect to single-phase alternating current
and only to the mains voltage specified on the rating
plate. Connection is also possible to sockets without
a protective contact, as the design is protection class
II. Only connect the machine to the socket when it is
switched off.
Maintenance
Always disconnect the plug from the socket before
carrying out any adjustment, maintenance or repair
work on the appliance
Always carry out a visual inspection before each
operation.
The device must not be used if it is damaged or if
the safety devices are defective. Replace worn and
damaged parts.
Caution! If the power cord of this device is damaged,
it must be replaced by the manufacturer or its custo-
mer service or a similarly qualified person in order to
avoid hazards.
Repairs and work not described in this manual
should only be carried out by qualified personnel.
Use only original accessories and original spare parts.
Make sure that the tool is disconnected from the
power supply before attaching or removing the saw
blade.
Replace worn table inserts.
Always keep the machine clean, especially the
ventilation slots. Never hose down the device body
with water!
Do not clean plastic parts with solvents, flammable
or toxic liquids. Use only a damp cloth for cleaning.
Treat all moving parts with an environmentally
friendly oil.
Only a regularly maintained and well cared for device
can be a satisfactory aid. Lack of maintenance and
care can lead to unpredictable accidents and injuries.
If required, you can find the spare parts list on the
internet at www.guede.com.
disposal
Waste batteries and waste electrical
and electronic equipment must
not be disposed of together with
household waste. Waste batteries
and waste electrical and electronic
equipment must be collected and
disposed of separately. Remove used
batteries, accumulators and lamps
from the devices before disposing of
them. Ask the local authorities or your
retailer about recycling centres and
collection points. Depending on local
regulations, retailers may be obliged
to take back used batteries and waste
electrical and electronic equipment
free of charge. Help reduce the
demand for raw materials by reusing
and recycling your used batteries
and waste electrical and electronic
equipment. Waste batteries (espe-
cially lithium-ion batteries) and waste
electrical and electronic equipment
contain valuable, recyclable materials
that can have a negative impact on
the environment and your health if
not disposed of in an environmentally
friendly manner. Delete any personal
data on your old device before
disposing of it.
Guarante
The warranty period is 12 months for commercial use
and 24 months for consumers, starting from the date
of purchase of the device.
The warranty covers only defects that can be attribut-
ed to material or manufacturing defects. When asser-
ting a claim under the warranty, the original proof of
purchase with the date of sale must be enclosed.
The warranty does not cover improper use, such as
overloading the device, use of force, damage caused
by external influences or foreign bodies. Non-compli-
ance with the operating instructions and normal wear
and tear are also excluded from the warranty.
Publicité
