Publicité
5. ¢7-05 Insert the pouring spout into the opening on the shield.
6. ¢7-06 Push the outer shell and breast shield together tightly, ensuring it is fully sealed
all the way around until you hear a snapping sound.
7. ¢7-07 Connect the long end of the tubing to the motor unit as far as it will go.
8. ¢7-08 Connect the short end of the tubing into the tubing connection port on the
collection cup.
Information
O-ring fits all breast shield sizes. To disassemble and assemble the O-ring to a different size
of breast shield follow the guidance below.
If you would like to use a different size of breast shield, disassemble the already applied
O-ring from the 24 mm breast shield starting by pulling out the bottom tab (as shown in the
left imagine below) from the breast shield. To reassemble the O-ring to a different size of
breast shield, start from the top (as shown on the right imagine below) of the breast shield,
stretch it over the outer edge of the breast shield. Ensure it goes on with the ridges facing
outwards. Press along the groove, checking that it is in place all the way around.
To disassemble:
Pull out the bottom tab from here
7.3 Preparing for single pumping
Refer to figure ¢8 on the foldout pages.
1. Assemble one collection cup as described in chapter 7.2.
¢8-01 Insert the unused tubing end into the Y-shaped tubing holder.
¢8-02 Correctly assembled system (for single pumping).
2. ¢8-03 Place the collection cup in your bra according to chapter 7.5.
Start pumping as described in chapter 9.
7.4 Preparing for double pumping
Information
• Double pumping saves time and increases the nutritional value of the milk.
• For the delayed start function see chapter 8.5.
Refer to figure ¢9 on the foldout pages.
1. Assemble the two collection cups as described in chapter 7.2.
¢9-01 Correctly assembled system (for double pumping).
2. ¢9-02 Place the collection cups in your bra according to chapter 7.5.
Start pumping as described in chapter 9.
15400140_A_0523-Freestyle-Hands-free-MD-IFU-EN-FR-ES_052323.indb 17
15400140_A_0523-Freestyle-Hands-free-MD-IFU-EN-FR-ES_052323.indb 17
To assemble:
Start placing the O-ring from here.
Ensure that
the ridges
are straight
17
2023. 05. 23. 14:44
2023. 05. 23. 14:44
Publicité
