Publicité
16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
17 TROUBLESHOOTING
Danger due to electrical voltage! Handling the machine with the power supply up can
lead to serious injuries or even death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional or
unauthorised reconnection!
Problem
Saw blade gets loose
after turning off the
motor
Motor does not start
Wrong direction of motor
rotation
Motor unable to run – the
fuse is tripped
Burns on the cutting
surface
ZIPPER MASCHINEN GmbH
ZI-WP500TN
WARNIUNG
Possible cause
• Fastening nut tightened
insufficiently
• 1. Failure mains fuse
• 2. Extension cable defective
• 3. Connections of the motor or
switch defect
• 4. Motor or connections defect
• Capacitor defect
• Cross section of the extension
cable insufficient
• Overload by dull saw blade
• Dull saw blade
• Wrong saw blade
www.Zipper-Maschinen.at
TROUBLESHOOTING
Fault eleimination
• Tighten fastening nut (right-
hand thread)
• 1. Check mains fuse
• 2. Exchange extensions cable
• 3. Have it checked by an
electrician
• 4. Have it checked by an
electrician
• Have it checked by an
electrician.
• See the wiring diagram in the
manual
• Exchange saw blade
• Insert sharpened saw blade
• Exchange saw blade
30
Publicité
